Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Chimney Company in Costa Mesa, CA
Chimney repair in Costa Mesa usually means cracked clay flue tiles, rusted dampers, and mortar joints worn down by salt air. Most homes here were built between the 1950s and early 1970s, and a lot of those original masonry fireplaces have never been touched. When a chimney sits unused for years, the damage doesn’t announce itself. It shows up when someone finally lights a fire or when a home inspection flags it. Supreme Chimney Sweep has served Costa Mesa since 2012, and we handle the full repair scope: caps, crowns, flashing, and liners. Call (833) 589-8164 for an estimate.
Why Costa Mesa Homes Are Different
Costa Mesa’s coastal marine layer does two things to a chimney. It keeps the air damp enough that creosote from occasional fires stays gummy rather than turning into the hard glaze you see in colder climates, and it carries salt that eats at mortar joints year after year. The west side near 92627 has older bungalows from the 1940s and 1950s, some with chimneys that were retrofit rather than original. The east side, especially in 92626, is mostly 1960s tract housing where the flue is clay tile and the crown was poured thin at the corners. Santa Ana winds push leaves, palm fronds, and debris onto chimney caps, and we regularly pull nesting material from flues that haven’t been used in a decade. In the tracts around 92626, decades of minor seismic movement have cracked original clay flue tiles in ways homeowners don’t see until a camera goes up. That’s the job here: finding what time and salt and settling have already done.
Styles & brands we work with
Our Main Costa Mesa Services
Most Costa Mesa homeowners call us for one of two reasons: a chimney that hasn’t been inspected in years, or a dryer vent that’s never been cleaned at all.
Chimney Sweep in Costa Mesa
A sweep in Costa Mesa isn’t really about heavy soot. It’s about nests, debris, and creosote that built up slowly over years of occasional use. In 92626 tract homes with original clay flues, the sweep often reveals hairline cracks that were invisible from the hearth. We run a camera on every job, and we document what we find. If a flue tile is cracked, you’ll see it with your own eyes before anyone quotes a liner. Chimney Sweep in Costa Mesa covers the full scope, from Level 1 inspections to full cleanings.
Dryer Vent Cleaning in Costa Mesa
Dryer vents clog with lint slower in Costa Mesa than in humid climates, but the homes here have long vent runs. A dryer on the far side of a 1960s ranch in 92626 might push exhaust 20 feet or more before it exits, and every bend collects lint. That’s a fire hazard, and it’s one most homeowners never think about until the dryer takes two cycles to finish a load. We clean the vent and document the airflow before and after. Dryer Vent Cleaning in Costa Mesa treats this as a fire-prevention service, not an add-on.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Chimney Repair in Costa Mesa
Chimney repair in Costa Mesa is mostly structural work on 50 to 70 year old masonry. The two jobs we see most are clay flue tiles cracked by decades of settling, and mortar crowns worn down by salt air and Santa Ana wind. Because we carry structural components and liners on the truck, damage we find during a sweep can usually be addressed the same day instead of turning into a second appointment with a different contractor. Our repair scope covers Chimney Repair from cap to crown, and we stock HeatShield, DuraFlex, Gelco, and Olympia Chimney parts so we’re not waiting on a supplier to finish a job.
Chimney Cap Installation
Signs you need it
You see rust flakes on the hearth, hear animals in the flue, or notice water staining on the firebox walls after rain.
What it costs in Costa Mesa
Installing a stainless steel or copper cap with a screened arrestor in Costa Mesa runs $240 to $490 depending on flue size and roof access.
How we do it
We measure the flue, select a Gelco or Olympia cap with proper screen mesh, secure it to the flue or crown, and verify draw before leaving.
Chimney Crown Repair
Signs you need it
The crown has visible cracks, the mortar is crumbling at the edges, or water is pooling on the surface after a light rain.
What it costs in Costa Mesa
Cracked crown repair with a proper waterproof sealant in Costa Mesa runs $300 to $650; full crown rebuilds where the concrete has failed typically run $850 to $1,400.
How we do it
We clean off the old surface, patch or pour a new crown with a tapered overhang for water runoff, and seal it against salt-air moisture.
What Chimney Repair Costs in Costa Mesa
| Service | Typical range in Costa Mesa |
|---|---|
| Chimney cap installation | $240 – $490 |
| Chimney crown repair | $300 – $650 |
| Flashing repair | $300 – $900 |
| Clay flue tile repair / partial reline | $850 – $2,800 |
How do I know if my Costa Mesa chimney needs repair or just a sweep?
A sweep clears what’s on the surface. If the flue tile is cracked, the damper is rusted open, or water has been getting in, no amount of sweeping fixes that. We camera-inspect on every sweep, so you see the condition yourself. Call (833) 589-8164 and we’ll tell you straight whether repair can wait.
Can you repair a cracked flue without tearing out the whole chimney?
In many Costa Mesa homes, yes. HeatShield resurfacing can restore a cracked clay flue without a full liner replacement, at a fraction of the cost. We’ll recommend it only if the camera footage shows the flue is a good candidate for it. Call (833) 589-8164 to schedule an inspection.
Brands We Service in Costa Mesa
We stock and install DuraFlex liner systems, HeatShield resurfacing materials, Gelco caps and dampers, and Olympia Chimney components on Costa Mesa jobs. These are the same lines specialty chimney contractors specify nationwide. If you need a new cap, damper, or liner, we usually have the right part on the truck, which keeps the job moving. See our brands for the full list of what we work with.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Company in Costa Mesa, CA
Upfront pricing matters, especially in Costa Mesa where a repair quote can vary from one side of town to the other. Here’s what we charge for the common work.
| Service | Typical range in Costa Mesa |
|---|---|
| Chimney sweep (standard, Level 1) | $180 – $310 |
| Chimney sweep with Level 2 camera inspection | $350 – $550 |
| Chimney cap installation | $240 – $490 |
| Chimney crown repair | $300 – $650 |
| Flashing repair | $300 – $900 |
| Clay flue tile repair / partial reline | $850 – $2,800 |
| Full stainless liner (DuraFlex) | $2,800 – $4,900 |
| Masonry repointing (per section) | $400 – $1,100 |
| Chimney cap replacement (with new arrestor) | $280 – $520 |
| Dryer vent cleaning | $120 – $260 |
Roof pitch and chimney height push prices up in Costa Mesa, especially on two-story 1960s builds in 92626 where the chimney chase runs tall. Flue access is another factor; an offset flue or a tight chase adds time. Whatever the job, we confirm a flat price before any work begins, so the quote on the phone is the number on the invoice.
Neighborhoods We Serve in Costa Mesa
We work everywhere in Costa Mesa, from the Mesa Verde tract in 92626 to the older bungalow streets near the west side in 92627 and the eastside communities in 92628. Our typical response time for a sweep or repair estimate is one to two business days, depending on the week’s schedule.
- Mesa Verde
- College Park
- Eastside Costa Mesa
- Westside Costa Mesa
- Liberty Park neighborhood
Service Area – Cities Near Costa Mesa
Supreme Chimney Sweep also covers the neighboring communities along the 55 and the coast. Homeowners in Newport Beach, CA and San Joaquin Hills, CA call us for the same salt-air and aging-flue issues we see in Costa Mesa. Inland, Irvine, CA and Aliso Viejo, CA have newer housing stock, but vents and chimneys there still need the same camera-verified inspection we do everywhere.
Serving Costa Mesa, CA — Our Local Coverage Area
We’re based in the Costa Mesa area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Chimney Company in Costa Mesa
Typically one to two business days for an estimate, and many repairs can be scheduled the same week if the parts are on the truck. Emergency calls, like water actively leaking into the firebox, go to the front of the line. Call (833) 589-8164 and we’ll give you a straight answer.
Some Costa Mesa HOAs require approval for visible exterior changes, like a new chimney cap. Most sweep and interior repair work needs no approval. We can tell you which approvals apply after we see the job, and we’ll work with your board if needed.
Yes. One appointment can cover a chimney sweep, a repair quote, and a dryer vent cleaning in Costa Mesa. It’s the same company, same crew, same documentation. Call (833) 589-8164 to schedule both and we’ll build one route around your street.
What happens when you call
- 1A real person answersNo phone trees — talk to a local chimney cleaning pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Costa Mesa Customers Say
"Liner was cracked in two places. He walked me through the repair options honestly, including the one that was cheaper for him and better for me."
— Adam Novak"Fireplace had never drawn properly since we moved in. He found the damper was only opening halfway due to a bent linkage and fixed it in ten minutes."
— Emily Tran"Good work. The written inspection report took about a week to arrive after I asked for it, which was slower than I expected."
— Justin Lin